AeroHeadTW’s Radian Pro Mix for the DX7s
I'm fairly new to gliders, so I’m sure you fellows out there can improve on my mix or perhaps someone can get the mix from Horizon running (perhaps it uses a 7 channel rx with flaps not on a Y-cable?).
AeroHeadTW Radian Setup
Rx is AR600
Right aileron is plugged into Ail on rx
Left aileron is plugged into Aux 1 on rx
Flaps on Y-Cable plugged into Gear on rx (setup this way on a 6 channel rx, I think you can't get full trailing edge with flaps following ailerons--but my mix for the ar600 does have reflex, camber, 2 x flaps and crow/spoiler.)
Model Type: Acro
Wing: 2 ail, 1 flap (not 2 flap because of y cable)
TRAVEL: I might still tweak a figure here for one of the servos . . .
Sub Trim: Left Ail 50+ (the arm on the left aileron servo was at a different angle than the right—yours will likely be different—I didn’t want to undo the servo tape or cut wing foam to get to the arm screw)
Right Ail, Elevator, Rudder, Flap, Left Aileron & Aux 2
Set for throws in manual (or quite a bit higher ; ) —activated by Rudd D/R switch)
. . . . . . . .Flap . Elev
Norm . . .0 . . . . 0
Mid . . . .50 . . . 11
Land . .100 . . . 22
Speed: 1.4s Switch: Flap
Ail > Rud Mix (I don’t use this much as I like hammerheads) :D
Right -40%, Left -40%, Switch: Mix 1
>Mix 1: (Ailerons up for Crow)
Ail > Lal: 100%, 100%, Offset: -65%, Switch: Ele D/R
Mix 2: (Make R ail move during crow)
Ail > Ral: 125% (set to compensate for some asymmetry—yours will likely be different), 100%, Offset: 0, Switch: Ele D/R
Mix 3: (sets knob to control camber and reflex on ailerons)
Knb > Lal: -32%, -32%, Switch FM1
Mix 4: (sets knob to control camber and reflex on flaps)
Knb > Flp, 11%, 16%, Switch FM1
One big caveat:
I haven't flow this mix yet, but it seems great on the ground.
I might need to add some elevator compensation to the reflex/camber knob.
Horizon/Spektrum/Parkzone hopes to post an approved mix to DX7s Airware soon
Download file: HERE